[Bug] - fault loops are not detected #136

Version

3.1.12 0.1.3

Bug Description

Map2loop does not slip faults that share the same name and create a loop. This causes the resulting fault surfaces to not work correctly.

In the case below purple should be split into two faults and blue should be split into two faults. It could also be worthwhile merging purple and blue because they create a continuous fault.

Minimal reproducible example

Use Loop sources notebook and look at fault 14655 and 16399

Expected Behavior

map2loop should pick out faults that are not labelled correctly or will create invalid geometries. This could be as simple as looking at the tangent of the line segments of a fault and if the different between two segments is > a threshold the fault is split into two faults.

Actual Behavior

Map2loop does not check the fault geometries

Additional Context

No response

Environment

n/a

Severity

• Low
• Medium
• High
• Critical